Welcome to our store. Learn more
What Lens or Mirror Should I Buy for My CO₂ Laser Machine? Find the Right Replacement Optics in Minutes Choosing the wrong laser lens or mirror can reduce cutting performance,...
Jamie Pieper |
American Photonics - 100% made in America With quality control. ISO We have more than 4000 lens part numbers. Here are the most popular part numbers for marking...
Ana Walters |
In a high energy laser situation like Co2 laser, there are 2 things that make a better mirror (energy loss is not a big deal, absorption is): The loss of...
Ana Walters |
Beam alignment is #1; optic quality is #2; and focal point is #3 Beam Alignment: You will never be 100% satisfied with your machine until you learn to master this...
Ana Walters |
The short answer is "NO". There is no advantage to a bigger diameter lens.The long answer is "it depends".Is the beam diameter more than 70% of the diameter of the...
Ana Walters |
No question, everything being perfect a 1.5” will give the best results! Everything being perfect, a 1.5” lens can easily achieve 500dpi: Perfectly flat part Perfectly level bed Perfect beam...
Ana Walters |
American Photonics don't feel you should ever touch your lens. That's why we've developed an easier, cost-efficient way to replace and clean it without dropping it, or getting the oils from your...
Ana Walters |
By HP Persson DIY & how-to, Lens & mirrors alignment, K40 laser cutter, K40D laser cutter, Laser head, Lens, Mirrors 13 Comments Focus is very important for your work, if you are out of focus you will lose power or get strange effects...
Ana Walters |
If you're looking to buy one of our lens stems, but you're unsure on the correct diameter, here it is an easy way to find out: Just measure the diameter of...
Ana Walters |
A focal length is the distance between the upper surface of substrate and the bottom of the lens, and the height will depend on what you're looking to do with your...
Ana Walters |
''I'd like to order the alignment tool but not sure what size to buy''. If you're not sure about the correct alignment tool size you need, there's an easy way...
Ana Walters |
Dear Customer, This year of 2020 has been quite the year so far. We have all experienced new challenges while learning to adjust to a “new normal” with each passing...
Ana Walters |
Chick on the picture to open our ebook and learn about American Photonics:
Ana Walters |
Unlock Exclusive Discounts: Join Our Email List
